BREAKING through April on this accessory

The filling system is that it is necessary to install a float in the water tank and connects a EasyGreen a tap water supply. This makes your EasyGreen fully automatic. The float comes bare, with its output 1 / 4 inch.

The output 1 / 4 inch plug into a water supply. If you're handy, you will probably find a connection between your faucet to an output 1 / 4 inch. Otherwise, you can order one of two kits fittings proposed below:

If you want to connect your EasyGreen a kitchen faucet, please choose the most:

- Kit Kitchen Faucet

If you want to connect your EasyGreen a tap washer or dishwasher, please choose the most:

- Kit valve washing machine / dishwasher

If you buy several hotbeds, note that an automatic filling system is essential for EasyGreen.

The filling system installs in minutes. Just drill a hole diameter of 10 to 12 mm in the hull of the propagator with ideally a drill and put the float in the tank. A sharp knife can also be used, but the result is less clear. Detailed explanations in the manual.